zbCAD/Taper Studio
Export Project
—

Taper Studio

Lays out tapered insulation for a low-slope roof. Draw the roof, place the drains and curbs, and it builds the taper down to the drains, adds crickets between drains and behind curbs, matches every module to a panel from your tapered series with flat fill under it, and works out the R-value and a material takeoff. The result exports as a shop drawing, a layered DXF, an Excel workbook and a CSV.

Getting started

Sample loads a worked example. New starts a blank 100′ × 60′ roof with no drains. Undo takes either one back. Everything recalculates as you type or drag. The tabs on the left are worked in order: Roof, then Taper, Panels, R-value and Takeoff.

Roof

Taper

Panels

A series is one manufacturer's set of tapered panels at one slope. Enter its panels from the thinnest up, with the low and high edge of each. The series repeats as a cycle: after its last panel it starts over on flat fill equal to the cycle's rise. The Progression line shows the sequence that results. A red step there means the fill thicknesses you listed can't make that step exactly. Crickets use whichever series is closest to the cricket slope. The presets are generic profiles; check codes and sizes against your manufacturer's data.

R-value and takeoff

Shortcuts

V R D S C E HSelect, Roof, Drain, Scupper, Curb, Edge, Pan
FFit the roof in view
Scroll, pinchZoom
Space + drag, middle dragPan from any tool
DeleteRemove the selected drain, curb or corner
EscCancel the outline being drawn, clear the selection
Ctrl+Z / Ctrl+Shift+ZUndo / redo

Files

This is a layout and estimating aid. Check panel sizes and R-values against the manufacturer's data, the R-value method against the governing energy code, and slopes and crickets against the roof system's requirements.

Free to use, provided as is, with no warranty: see the terms of use.